9 Signs That You're An Expert Fiat 500 Replacement Key Cost Expert
Fiat 500 Replacement Key Fob
It may be time to change the battery if your 500 remote key fob is not working. If you replace the battery but it doesn't work it could be the issue somewhere else.
At United Locksmith, we specialize in the creation of new keys for classic cars. We have all of the necessary tools and parts for this service.
Dead Coin Battery
The most frequent reason why your Fiat 500 key fob will not unlock or lock the doors is due to a dead battery. The coin cell battery in the key fob will drain quickly when you don't use it often enough. If your remote starts to show signs of loss of range or has stopped working and the battery is not working, it could be dead.
The battery inside the key fob is held in place by steel clips for retaining. If the clips are loose they can cause contact issues, which could prevent your remote from receiving power. Make use of a flathead screwdriver to pry open the retaining clip and remove the old battery. Choose a battery that is the same size, voltage and specifications as the original.
The exposure to water can cause the key fob to corrode or become damaged. Even a brief bath in warm, soapy water can cause damage to the chip. Make sure your key fob is dry.
Water Damage
If your key fob isn't working properly, it may be caused by water damage. The rubber seals on key fobs protect them from getting damaged by a tiny drizzle or splash of water. However, it is crucial to keep your car keys away from the washing machine, the ocean, and the pool.
The key fob has an electronic chip that sends an immobilizer system of your car. This is what allows your 500 to lock or start, but when the chip becomes wet, it will no longer work.
You can clean the inside of your key fob's electronics using isopropyl alcohol or an electronic cleaner to determine whether they're still in good condition. However, it is probably best to get a replacement from a dealer instead of trying to fix the key fob which has been submerged by salt water.
While fiat ducato replacement key might cost you a little bit of money, it's far less expensive than paying for your Fiat 500 to be towed to the dealer and repaired! In addition, you can do it yourself in the simplest of steps. Just ensure you have the right battery type before you attempt to open your key fob. You can find step-bystep directions for every car keyfob online.
Faulty Chip
The chip located within the key fob communicates with your car's immobiliser unit to ensure your car is only able to start when the correct key is used. If the chip is damaged or damaged in any way, your car will not start.
A faulty chip can occur due to several reasons, but the most common cause is water damage or the battery being dead. Regardless of the reason, it's an ideal idea to hand this task to a locksmith who will be able to replace the chip for you quickly and at a reasonable cost.
If your key fob will not work after being exposed to clean tap or rain water take the battery off. Clean the electronic component with paper towels. If the key fob does not function, there is a chance that it has malfunctioning components and need to be replaced.
A few people turn to their dealer when in need of an entirely new Fiat key fob, but this can be a very costly alternative. If you're seeking a cost-effective method to have your Fiat key fob fixed, look no further than United Locksmith. We have the tools and experience needed to repair your Fiat key fob in a quick and professional way.
Faulty Receiver Module
Fiat key fobs transmit an electrical signal to the vehicle, which will unlock and close doors (and start the car for those with an automatic transmission) up to 50 feet. There are a few reasons why the fob might stop working. This could be due to a dead coin battery damaged by water or worn buttons and a receiver module issue and signal interference or a malfunctioning electronic chip.
If the fob was placed in the pocket that has been subject to severe trauma (such as being dropped onto the floor or washed in a washing machine), it may not be able to communicate with the Body Control Module (BCM) of the vehicle. This is because the BCM is an extremely secure system that will only accept signals from a genuine original key and not accept any other.
It is necessary to replace the fob in case this occurs. A professional locksmith can take care of all aspects of the replacement process as well as programming a new one for your 500. In fact, they can offer you a clone key that functions the same way as your original fob (and costs only a fraction of the cost).